xtremegaq.blogg.se - How to sublimate on wood

We’ll go over the steps in more detail below. Remove the transfer paper and sponge off any remnants stuck to the wood.Press at 385 degrees Fahrenheit for 60 seconds using medium pressure.

Place the wood under the heat press sandwiched between two sheets of parchment paper.Print your design, trim it, and attach it to the wood using heat-resistant tape.Apply a thin layer of polycrylic to the surface.Prepare the wood for sublimation by sanding it.In summary, to sublimate on wood, do the following: Is It Possible to Sublimate on Bare Wood?.Alternative Coatings You Can Use to Prep Your Wood for Sublimation.Step Three – Trim the Design and Stick It on the Wood.Step Two – Prepare and Print the Design.If you follow these 3 simple steps for MDF sublimation, you are guaranteed to have a great subbed image on MDF wood substrate. So, be sure to sub one side and then let your blank cool a bit and then go ahead and flip it to sub the other side next. We are all for doing things fast, but you can't sub both sides of MDF at the same time because of what we said in point #2.

Do not try to sub artwork on both sides at the same time.

Sublimation Blanks Company's MDF blanks are always 2-sided (except for our magnets, of course).

So, in the case of MDF especially-your blank goes on the bottom and your artwork in always on top! It's very hard for heat to travel through a dense wood product that is 1/4" thick.

When you place your MDF sublimation blank on your heat press, your artwork MUST FACE UP! In most heat presses, the top platen is the one that heats up, and not your bottom one.

You've got to remember to remove this film by using your fingernail or even the tip of a sharp X-Acto knife to remove it.

Most sublimation MDF has a clear protective film on it to keep your blank from getting scratched or dinged.